Roofer nailing shingles above a new metal drip edge on a coastal Texas home
Windstorm code · TWIA area

WPI-8 Windstorm Roof Replacement in Angleton & Brazoria County

All of Brazoria County is in the Texas windstorm area. If your home has or may need TWIA wind coverage, most roof replacements must be inspected while the work is done to earn a WPI-8 certificate. Here's how it works.

  • Built to the windstorm code
  • Inspection during the work
  • WPI-8 for TWIA eligibility

What is a WPI-8?

A WPI-8 is a Certificate of Compliance issued by the Texas Department of Insurance (TDI). It shows that a new roof, repair or addition on the Texas coast meets the windstorm building code. The Texas Windstorm Insurance Association (TWIA) uses it to decide whether a home can get or keep windstorm and hail coverage.

Without a WPI-8, you could have trouble getting TWIA coverage, renewing it, or selling to a buyer who needs it. That's why the windstorm inspection should be part of the plan for any roof replacement in Brazoria County, not an afterthought.

The rules apply to the work, not the material. A metal roof needs the same kind of inspection as a shingle roof.

How it works

How the WPI-8 process works for a new roof

These steps follow the Texas Department of Insurance's own process.

  1. Before work starts

    An inspector is lined up and an application (form WPI-1) is filed with TDI. State law requires the application before construction begins.

  2. During the work

    A TDI windstorm inspector or a TDI-appointed engineer checks the roof while it's going on. TDI requires inspectors to see the work in progress.

  3. After the work

    The inspector sends in the paperwork. Once TDI approves it, the WPI-8 shows up on TDI's website. TDI says to allow about three working days.

  4. Keep it safe

    Store your WPI-8 with your insurance papers. You'll need it for TWIA, and buyers often ask for it when you sell.

What makes a roof "windstorm code"

The windstorm code covers how the roof is built, not just what's on top. Inspectors look at things like the products used, how the decking is fastened, the nails and nailing pattern, the underlayment, the drip edge, and how the shingles are sealed at the edges and ridge. Products must be approved for windstorm use, and they have to be installed the way the manufacturer specifies for high winds.

If a roof was replaced without an inspection, it can sometimes still be certified later through a post-construction inspection by a Texas licensed professional engineer, which leads to a certificate called a WPI-8-E. That can be harder, since the engineer can't see the work that's already covered up. It's much easier to plan the inspection from the start.

Ready to replace your roof? Our roof replacement page walks through the whole job, step by step.

Know before you start

Which roof work needs an inspection?

Usually needs a windstorm inspection

  • Full roof replacements
  • Re-roofing a large section
  • Repairs that involve replacing decking
  • Roof repairs of 100 square feet or more

Usually doesn't need one

  • Roof repairs under 100 sq ft that don't involve decking
  • Repairing or replacing gutters
  • Painting and other non-structural work

Not sure? TDI suggests contacting your local windstorm inspections office before you start any work. You can reach TDI's windstorm line at 800-248-6032.

FAQ

Common questions

Do I need a WPI-8 for a new roof in Angleton?

In most cases, yes. Angleton is in Brazoria County, which is in the TWIA coverage area. Most roof replacements and major repairs here need a windstorm inspection and a WPI-8 certificate to stay eligible for TWIA coverage. Small repairs under 100 square feet that don't involve the roof decking usually don't need one.

Can I get a WPI-8 after the roof is already finished?

Sometimes. If the work was done without an inspection, a Texas licensed professional engineer can do a post-construction inspection, which leads to a WPI-8-E. It can be harder, because the engineer can't see parts of the roof that are already covered, so it's best to plan the inspection before work begins.

How do I check if my home already has a WPI-8?

You can look up a property's certificate of compliance on the Texas Department of Insurance windstorm website. Certificates issued by TWIA (called WPI-8-C) between January 1, 2017, and May 31, 2020 have their own lookup on TWIA's website.

Does a metal roof need a WPI-8 too?

Yes. The windstorm rules apply to the roofing work, not the material. A metal roof replacement in Brazoria County needs the same kind of inspection as a shingle roof, using products approved for windstorm use.

Also helpful

Related services

Roof Replacement

The full roof replacement process, from tear-off to cleanup.

Learn more →

Metal Roofing

Metal roofs need a WPI-8 too. See your metal options.

Learn more →

Need a new roof that passes windstorm inspection?

Call us and we'll walk you through it, 24/7.

Call (979) 555-0142
Call Now: (979) 555-0142